1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Water loop temp sensor for OSD

Discussion in 'Rivatuner Statistics Server (RTSS) Forum' started by Olshan, Dec 28, 2018.

  1. Olshan

    Olshan New Member

    Messages:
    2
    Likes Received:
    0
    GPU:
    EVGA 1080 Ti SC
    I'm trying to get my temp sensor for my water cooling loop to show in the OSD. It is connected to a temp sensor on my motherboard (Gigabyte Aorus Gaming 7).

    I am using Ravi with MSI Afterburner.

    Has anyone had any luck with this? I did some research, but I'm relatively new to PC building and I'm a little lost.
     
  2. BlackZero

    BlackZero Ancient Guru

    Messages:
    8,880
    Likes Received:
    469
    GPU:
    RX Vega
    HWinfo will allow you to monitor all sensor readings in MSI Afterburner OSD.

    Simply tick the OSD setting for each individual sensor in HWinfo, and run before MSI Afterburner.
     
    jaggerwild likes this.
  3. Unwinder

    Unwinder Moderator Staff Member

    Messages:
    14,394
    Likes Received:
    1,417
    Alternately, just install HwInfo and setup HwInfo plugin in MSI AB. This way you'll be able to configure this value/graph in OSD using MSI AB's native hypertext formatting.
     
  4. Olshan

    Olshan New Member

    Messages:
    2
    Likes Received:
    0
    GPU:
    EVGA 1080 Ti SC
    That worked great, thank you!

    Fyi the Germany link downloads Open Hardware Monitor, not HWiNFO64.
     

Share This Page