Thermaltake Enters the Memory Market - launches WaterRam RGB

Discussion in 'Frontpage news' started by Hilbert Hagedoorn, Jan 10, 2019.

  1. Hilbert Hagedoorn

    Hilbert Hagedoorn Don Vito Corleone Staff Member

    Messages:
    37,380
    Likes Received:
    6,398
    GPU:
    AMD | NVIDIA
  2. schmidtbag

    schmidtbag Ancient Guru

    Messages:
    4,778
    Likes Received:
    1,549
    GPU:
    HIS R9 290
    Seems pretty unnecessary, but it sure looks nice.
     
    reix2x likes this.
  3. reix2x

    reix2x Master Guru

    Messages:
    292
    Likes Received:
    40
    GPU:
    HIS 4870 1GB
    Memory never get that hot.. probably you will be heating up your ram modules.. bit if you want a very loopy water loop its ok, it looks nice also..

    this remembers me this jewels:
    [​IMG]

    so unnecessary, so beautiful!
     
  4. Robbo9999

    Robbo9999 Maha Guru

    Messages:
    1,455
    Likes Received:
    244
    GPU:
    GTX1070 @2050Mhz
    Seems a bit OTT to me! I'm not aware of RAM cooling being an issue, unless you're putting silly volts through it, but then it would die soon anyway at those high voltage levels.
     

  5. schmidtbag

    schmidtbag Ancient Guru

    Messages:
    4,778
    Likes Received:
    1,549
    GPU:
    HIS R9 290
    I personally opt for well-disciplined volts with a strong sense of independence and responsibility :p

    On a serious note though - I'm sure you're right. I don't even think people who use LN2 bother with cooling their RAM to such an extent. I'm sure active air cooling would be recommendable if you were to exceed something like 4.4GHz but even then, I don't think you'd need a fan pointed directly at your DIMMs.
     
    Robbo9999 likes this.
  6. SweenJM

    SweenJM Master Guru

    Messages:
    786
    Likes Received:
    463
    GPU:
    Sapphire 590 nitro
    Seems like ALOT of extra plumbing...
     
    DeskStar likes this.
  7. D3Master

    D3Master Member

    Messages:
    19
    Likes Received:
    3
    GPU:
    SLI Gigabyte GTX 1070 G1
    3200MHz C16-18-18-38 is NOT low latency. Those with time and money for this better go with 3200C14 and EK blocks etc. Also I find RAM blocks messy, but that's a personal preference.
     
  8. Undying

    Undying Ancient Guru

    Messages:
    12,652
    Likes Received:
    2,053
    GPU:
    Aorus RX580 XTR 8GB
    Lovely looking ram.
     
  9. DeskStar

    DeskStar Master Guru

    Messages:
    750
    Likes Received:
    105
    GPU:
    EVGA 2080Ti FTW3 HC
    And having said that....I knows a thing or two about that extra plumbing for sure. Built this bad boy from the ground up without a schematic whatsoever. On the fly if you will. And to throw in water on my ram would be just dumb as I've had ram fail that needed getting to easily.
     
    SweenJM likes this.

Share This Page