SLI rig running Vista x64

Discussion in 'RivaTuner Advanced Discussion forum' started by Passion Fruit, Dec 29, 2008.

  1. Passion Fruit

    Passion Fruit Guest

    Messages:
    6,017
    Likes Received:
    6
    GPU:
    Gigabyte RTX 3080
    I have another rig running an SLI setup.

    In RivaTuner, it's letting me drop down to three options.

    there is:

    GPU0 on a generic PNP monitor
    GPU0 (default monitor)

    those two both show the usual tweaking options

    and then there's:

    GPU1 \ unnatached device

    Is RivaTuner detecting the cards correctly?

    As you can imagine, both the GPU0 selections are controlling the first card, atleast as far as fan speeds, where is GPU1 is controlling the correct adapter's fan speeds.

    Am i mistaken to believe that it should be showing only GPU 0 and GPU 1 ? And should it be showing it as an attached adapter and not an unnatached device?
     
    Last edited: Dec 29, 2008
  2. Passion Fruit

    Passion Fruit Guest

    Messages:
    6,017
    Likes Received:
    6
    GPU:
    Gigabyte RTX 3080
    Just to Clarify,

    Both GPU0's have the card type after it but GPU1 is unnatached even with SLI enabled.
     
  3. Unwinder

    Unwinder Ancient Guru Staff Member

    Messages:
    17,126
    Likes Received:
    6,690
    Use serach!
     
  4. Passion Fruit

    Passion Fruit Guest

    Messages:
    6,017
    Likes Received:
    6
    GPU:
    Gigabyte RTX 3080
    I have, ive also been googling for half of the day. My friend managed to find someone with a similar problem on tech power up but that was posted on the 21st with no replies. Just to add, my thread was the only one that shows up on Guru3D search, and i managed to find it again using Google
     
    Last edited: Dec 29, 2008

  5. Passion Fruit

    Passion Fruit Guest

    Messages:
    6,017
    Likes Received:
    6
    GPU:
    Gigabyte RTX 3080
    This thread can be deleted.
     

Share This Page