Discussion in 'Videocards - NVIDIA GeForce Drivers Section' started by maur0, Mar 7, 2016.
No issues here(Win10 - 64bit) but i installed only PhysX and driver.
I got everything black and white with thees drivers.
Tried to reinstall, same. :bang:
No problems on an Optimus laptop, upgraded through GFE. Will report back when upgrading a two screen and then a three screen PC setup.
Installed and works fine for me in what i played so far, using two displays also.
Works like a charm, but then again I only installed the driver and PhysX.
dumb question, but if you can't get into safe mode how do you enable automatic restore point ?
PS: I am still on Win7 and honestly never had to use system restore .
If that happened to me, I'd probably do reinstall
ran DDU & installed with single monitor no issue here.
Drivers is perfectly fine on my end, no issues at all so far.
First time ever having an issue while installing nvidia drivers on my system. I got some artifacts during installation then pc rebooted and i had to use system restore to get back to a working environment. Will try installing with sli off.
Edit: Nope. Still getting artifacts. I guess i am skipping this version.
is that like right off fresh boot up how much ram is used on your system?? mine is like under gb and even after being on for 6+ hours and running and close the programs it under 1.5gb almost always when idle, ssytem is also turned of at night.
Then again i have 6gb ram, btw what build of windows you using? I dont see speed, slots used, form factor in my memory tab on win 10 10586.122
Not much more fps and i think my other bench with 361.91 was a other build of the game i think?
not so fine after all, just got this error and a blue screen The SYSTEM_SERVICE_EXCEPTION bug check has a value of 0x0000003B, pointed to the NVidia driver as the error. Never got this before, was trying to run Fallout 4
there is no aots improvement it seems
Downloaded from geforce.com and installed just fine but I've read on a few other forums about this "black & white" problem.
Just a little bit in all the benches, not much avg 3 fps. Its no failure number cause not 1 benchs in the list is the same.
This was a few hours after boot and after some gaming. It's pretty much always like this at idle:
Same build as you.
I also got the endless reboot BSOD loop. DDU did the trick as always
I have 1.7gb RAM in use, after reboot, nothing else opened.
Noticed that DSR is available in SLI mode
I tried installing it on my PC and it failed. Constant TDR's and a BSOD until I switched off my second display, it only resulted in displaying artifacts the way we see on dying hardware. Went back to 362.0 using system restore. Hope a hotfix will be swift.