SLI Bridge very close to case.

Hi all,

I've got a question. My SLI bridge is a flexible SLI bridge and a bit long for my needs. It works fine though.

However I worry about the fact that the bridge is about 2-3mm from touching the brackets in the case. The brackets are used for fastening PCI cards etc.

Should I have any worries since the bridge is covered in plastic? I mean - all the copper inside is protected from direct contact via the plastic.

You can see the type of SLI bridge here. (Danish site....)

 

Nothing to worry about i used to take my finger n bend the bridge in between both cards.

 

If you're worried could you bend it inbetween the cards instead of outwards?

 

Thank you both. Think I will try to push the bridge between the cards.

 

alternatively, you could go on ebay and buy shorter bridges.

 

I purchased a hard bridge from ebay for 7 bucks because my bridge was flexing into a fan.

 

The problem for me with buying a hard bridge is that I don't know how far apart the plugs are on the bridge = will the bridge fit my cards?