It seems to be buggy, e.g when switch between thresholds, the fan goes to like 30% for about 5 seconds when it should be switching straight from 50% to 60%. I liked the old threshold and offset method much better, was more reliable, and easier imo...
no its isnt, its doin it again. look at my settings but look what i get: and this time fan 50 is definately 50% sped, but its not kicking in, just look at the fan speed graph, at the end of it, 20%!? :bang: at 57C?
I can imagine that the program is running wild ... With these settings there exists a gap between 56 and 57 degrees temperature, where there is no fan setting defined (so the default setting will be used, which could be that 20% that you monitored) Try setting the 'Range min' of the fan50% event to 56° (or set the 'Range max' of the fan40% event to 57°), but I would not maintain that 1 degree gap in which the program will seek the default fan speed ...
not for nothing, but there IS a rivatuner forum here at g3d... perhaps if you post there you might get the help you are seeking.