New Win10tp 10162 AMD WDDM 2.0 driver via Insider Update...

I know. I did just that.

 

Same here. Did that same error

 

Same Error.

 

That's the one!

 

Hate that ****, hang tight gettin em signed by leshcatlabs...

 

thanks

 

Sweet

 

I installed mine through the mega download earlier. I unpacked the file, then installed the Setup Information file in the AMD folder. Rebooted, then installed the drivers through the device manager. Rebooted, and And then installed the CCC2_install for good measure.

I do have my BCD edited for -testsigning on.

 

driver from the mega link installed via device manager but CCC is borked and only shows power and performance tabs but i dont actually use it anyway

the driver itself seems fine

 

Driver now signed.

 

Thanks!

 

Thanks. Downloading now. Can't wait to see results

 

Thanks bud!!! I do perfer to install throuogh the CCC.

 

API OVERHEAD TESTS 1040 vs 1023.7

http://i57.tinypic.com/156fhn5.png

http://i59.tinypic.com/jfvrmg.png

 

Will you marry me?
(Awesome! Thank you!)

Thanks for the quick and dirty test. They seem a tad slower than 1040. I'll check the file versions myself, and upload the DLL for the other thread too.

 

Anyone noticed the frame rate target control on these. Even n crossfire it works and win 8.1 as well

 

Too bad. 1023.7 a little slower.

 

Yeah i enabled it, glad it works.

 

Does it work good though? Last time I tried it, 60FPS cap had like 60ms frametimes.

 

Here is my API run with 1023.7 with DX12

http://www.3dmark.com/3dm/7610342

My previous this morning with 1023.5 with DX 12

http://www.3dmark.com/3dm/7606369

This last test (below) is not a true measure since I was on a previous Win 10 TP version but this uses the 1040 build.

http://www.3dmark.com/aot/38100

The test from today is with a fresh install non OC'ed GPUs Using Win 10 build 10162.