 |
|
|
|
 |
 |
 |
 |
|
|||||||
 |
 |
 |
RivaTuner Advanced Discussion forum This forum is intended for advanced comments, ideas and general discussion of the RivaTuner Utility which is hosted here at the Guru of 3D. This forum is visited by programmer himself - you can only post in this area with a minimum of 10 posts and 7 days forum membership.
|
|
 |
|
|
Thread Tools | Display Modes |
 |
O/C settings Consistent? |
 |
|
|
|
(#1)
|
|
Maha Guru
Videocard: geforce7800Gs 256mb
Processor: AMD Athlon XP 3200
Mainboard: FN41 Shuttle
Memory: TwinX 2.0GB Dual Channel
Soundcard: nforce soundstorm
PSU:
|
O/C settings Consistent? -
07-04-2003, 03:02
| posts: 828
Question for y'all...
I Overclocked my card no problems with Rivatuner...fine and dandy... Then i had to reformat my computer, install graphics drivers and rivatuner again... Now i opened up RivaTUner, then the Overclocking Tab ,and it said before it could do anything it had to detect my cards Memory and Clock settings...So i needed to reboot... When i Rebooted it detected them but at the Stock Speeds not the Overclocked ones SO....I went and Re-Overclocked the card back to what i had before i Reformatted and the settings were again Ok... Wouldnt the Card STAY OVERCLOCKED once it has already been done once?So basically Im asking if this is normal? THanks |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
(#2)
|
|
Videocard:
Processor:
Mainboard:
Memory:
Soundcard:
PSU:
|
07-04-2003, 23:19
| posts: n/a
formatting and reinstalling everything cleared the settings in windows/OS registry that altered the speed to oc-ed speed.
it's normal |
|
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Powered by vBulletin®
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright (c) 1995-2012, All Rights Reserved. The Guru of 3D, the Hardware Guru, and 3D Guru are trademarks owned by Hilbert Hagedoorn.