Guru3D.com Forums

Go Back   Guru3D.com Forums > Affiliates > MSI AfterBurner Overclock Application Discussion forum
MSI AfterBurner Overclock Application Discussion forum This forum is intended for MSI customers for questions on the AfterBurner Overclock Utility based off Rivatuner. In this section the users help each other out with answers as well as support staff from MSI.


Reply
 
Thread Tools Display Modes
MSI 7770 no unofficial underclocking memory
Old
  (#1)
xeridea
Newbie
 
Videocard: ATI Radeon x1950xt
Processor: AMD 4600+ X2
Mainboard:
Memory: 2 GB Corsair XMS
Soundcard:
PSU: Enermax 500w
Default MSI 7770 no unofficial underclocking memory - 06-28-2012, 00:22 | posts: 2 | Location: Georgia

I have an MSI HD 7770 (1020OC). I am wanting to underclock the memory, but it will only allow me to go 150 below core clock (1140/990 in my case). I have an HD 6850 as main card, and HD 6570 as other card. I can get the memory underclocked to 525 and 330Mhz on other cards with unofficial overclocking enabled. Problem is, if I enable unofficial overclocking, the 7770 is completely uncontrollable (sliders at 0, will not accept anything). My 6570 did this before, but I figured out it will work if I set it to extended desktop.

It doesn't matter if it is an extended desktop, and I have tried the disabling DLPS or whatever in registry (that didn't work at all, still need to swap extended desktop once when I restart to prevent staying to idle/2D clocks).

I want to underclock memory, because my GPGPU load is not effected by memory speeds, and it lowers temps by ~8C.
   
Reply With Quote
 
Old
  (#2)
msi-afterburner
Master Guru
 
Videocard: MSI N275GTX Lightning
Processor: Intel Core I7 870
Mainboard:
Memory:
Soundcard:
PSU: OCZ Silencer 910W
Default 06-28-2012, 10:15 | posts: 402

Hello~
Sorry, it is can't lower, maybe you can try CCC control.
But the Memory has a default operating frequency range.
Too high, too low will not work fine...
Thanks
   
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Powered by vBulletin®
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright (c) 1995-2012, All Rights Reserved. The Guru of 3D, the Hardware Guru, and 3D Guru are trademarks owned by Hilbert Hagedoorn.