Guru3D.com Forums

Go Back   Guru3D.com Forums > Hardware > General Hardware
General Hardware Want to talk about anything Hardware related? This is the place, you can discuss it here.


Reply
 
Thread Tools Display Modes
No video after crash to reset
Old
  (#1)
maxod
Newbie
 
Videocard: Nvidia GTX 570 1.2 GB
Processor: Intel i7 930
Mainboard:
Memory:
Soundcard:
PSU: Strider Plus 1000W
Default No video after crash to reset - 04-15-2012, 04:48 | posts: 1

So I installed The Legend of Grimrock, and it ran fine for a few seconds in the menu and suddenly the system reset itself. Tried running it again and it reset even sooner, and upon resetting there was no video.

I've tried everything from unplugging the power cable to swapping the video card between slots, but the video is just dead. POST, however, runs fine up to the boot code (FF on my board's LED POST display).

So now I'm trying to figure out if it's fixable (probably not), and whether the problem lies with the motherboard or the video card. I'm leaning towards motherboard because the video card was under no stress, and there was no burnt smell as a VRM blowout produces.

Any ideas?

Last edited by maxod; 04-15-2012 at 04:52.
   
Reply With Quote
 
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Powered by vBulletin®
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright (c) 1995-2012, All Rights Reserved. The Guru of 3D, the Hardware Guru, and 3D Guru are trademarks owned by Hilbert Hagedoorn.