 |
|
|
|
 |
 |
 |
 |
|
|||||||
 |
 |
 |
Rivatuner Generic Discussion forum This forum is intended for generic questions and discussion of the RivaTuner Utility. In this section the users help each other out with answers.
|
|
 |
|
|
Thread Tools | Display Modes |
 |
Rivatuner problem |
 |
|
|
|
(#1)
|
|
Newbie
Videocard: BFG Nvidia 7900GTO
Processor: Intel E6400
Mainboard:
Memory:
Soundcard:
PSU:
|
Rivatuner problem -
05-20-2009, 18:27
| posts: 1
I have a BFG Nvidia 7900GT, driver 175.19, bios 5.71.22.27.01.
The program has been working well, for 6-8 months, until recently when I tried pushing my OC up a bit. The problem I have is when I launch my game, the OC profile kicks in just fine, fans at 100%, but after 45-60 seconds, the low level fan goes down to a 20% level, the card overheats, I start getting artifacts. Dont know where the 20% came from, I dont have it set up in a profile. Back to square one. I have always had only 2 low level fan profiles, 25% and 100%. I reset the settings to default, then establish a new profile, tried again, same thing. So I disabled low level fan control, went to the direct control menu, set to 100% and applied, started the game up, same thing, fan speed goes back to 20% after a few seconds. Can't figure it out. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
(#2)
|
|
|
Maha Guru
Videocard: EVGA GTX 680
Processor: i72600K @ 4.5
Mainboard: Asus P8P67 Deluxe
Memory: 2 x 4 G Skill
Soundcard: X-Fi Extremegamer
PSU: BFG Tech EX-1200
|
05-20-2009, 22:46
| posts: 1,560 | Location: Pa
Quote:
|
|
|
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Powered by vBulletin®
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright (c) 1995-2012, All Rights Reserved. The Guru of 3D, the Hardware Guru, and 3D Guru are trademarks owned by Hilbert Hagedoorn.