 |
|
|
|
 |
 |
 |
 |
|
|||||||
 |
 |
 |
ATI Tray Tools This forum is intended for comments, ideas and general discussion of the ATI Tray Tools Utility which is hosted here at the Guru of 3D. This forum is visited by programmer himself.
|
|
 |
|
|
Thread Tools | Display Modes |
 |
powerplay-switch? |
 |
|
|
|
(#1)
|
|
Newbie
Videocard: ATI mobility x700
Processor: Pentium M 750
Mainboard: Intel 915m
Memory: DDR2 2x1gb
Soundcard:
PSU: milk
|
powerplay-switch? -
11-25-2008, 15:07
| posts: 12 | Location: ger
i prefer not to install the bloaty CCC and use ATT instead,
but now that i am using a notebook i am dependend on the powerplay feature. where can i set this to enabled/low ? if not with ATT how is this possible without CCC? the only tool i did find to support this is nhc, but it needs dotnet and i dont want to install it ... maybe a commandline switch with some ati exe? thx |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
(#2)
|
|
Moderator
Videocard: ATI HD6950
Processor: Intel C2Q Q9550 (3.4GHz)
Mainboard: ASUS P5E
Memory: 8Gb Patriot Viper
Soundcard: internal
PSU: 900W
|
11-28-2008, 11:27
| posts: 4,942
There are no such support in ATT. You can overclock your board depending on power state
 ATI Tray Tools. |
|
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Powered by vBulletin®
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright (c) 1995-2012, All Rights Reserved. The Guru of 3D, the Hardware Guru, and 3D Guru are trademarks owned by Hilbert Hagedoorn.