Default readings - Yellow exclamtion mark

Discussion in 'Rivatuner Statistics Server (RTSS) Forum' started by Sir Bob, Oct 2, 2008.

  1. Sir Bob

    Sir Bob New Member

    Messages:
    3
    Likes Received:
    0
    GPU:
    ATI Radeon 9600 256mb
    Hi,

    When running RivaTuner for the first time, (with no under/overclocking previously) it reports that my mem. clock is at ~200MHz and has a yellow exclamtion mark over the mem. picture, but that goes away when I put it up to 250MHz. I was just wondering if I should put it up to 250MHz (or more), or leave it as it is, seeing as it is at the default value?

    Sir Bob.
     
    Sir Bob, Oct 2, 2008
    #1
  2. Unwinder

    Unwinder Ancient Guru Staff Member

    Messages:
    17,198
    Likes Received:
    6,866
    Leave it as is. Recommended clock ranges and default clocks are flashed in VGA BIOS and recommended ranges don't match with defaults in some low-end VGA BIOSes. Notthing to worry about.
     
    Unwinder, Oct 2, 2008
    #2

Share This Page