Auto or user control

Discussion in 'MSI AfterBurner Application Development Forum' started by PURE_RAGE, Jul 4, 2014.

  1. PURE_RAGE

    PURE_RAGE Guest

    Messages:
    1
    Likes Received:
    0
    GPU:
    NVIDIA580/1536
    Hello all,

    Is there any benefit to using auto or user defined control as far as the fan control goes? I am at 39C @ 55% fan speed on a GTX580. In other words, what would or what do you use?

    Thanks in advance,

    RAGE
     
  2. EdKiefer

    EdKiefer Ancient Guru

    Messages:
    3,125
    Likes Received:
    394
    GPU:
    ASUS TUF 3060ti
    that is a hard answer to give, it depends on your needs , system use and hardware used .
    I would say if your happy with noise and performance heat wise, just leave it on auto, stock profile but if you want better cooling at any stage in vid card usage (idle to load) , then setup a fan profile .

    As for your question on what i use, I do have fan profile setup , I wanted higher idles fan speeds with more aggressive speed with temps going up as the fans are pretty quiet .
     
    Last edited: Jul 4, 2014

Share This Page