Adjusting Memory Latency

Discussion in 'MSI AfterBurner Application Development Forum' started by collinvue, Feb 26, 2012.

  1. collinvue

    collinvue Member

    Messages:
    48
    Likes Received:
    0
    GPU:
    ~ 169 GB/sec. currently
    +

    So much can be done w/ fine overclocking software, this is true.

    Would anyone like to be able to adjust/tighten latencies on their GPU memory;
    more importantly,..Is it possible?

    //
     
  2. rewt

    rewt Guest

    Messages:
    1,279
    Likes Received:
    15
    GPU:
    Yes
    Combined with overclocking, adjusting memory timings is probably the most likely way to cause permanent damage to the hardware, so I don't see MSI supporting it.
     
    Last edited: Feb 26, 2012
  3. collinvue

    collinvue Member

    Messages:
    48
    Likes Received:
    0
    GPU:
    ~ 169 GB/sec. currently
    ^

    There would be little if any memory OC if lowering latency.

    I'd rather lower my timings, than increase frequency.

    //
     
    Last edited: Mar 2, 2012
  4. djjonastybe

    djjonastybe Master Guru

    Messages:
    725
    Likes Received:
    0
    GPU:
    HD6950(70) 885/1350
    Why don't you use Nibitor to do it... I believe it can do that.
     

  5. collinvue

    collinvue Member

    Messages:
    48
    Likes Received:
    0
    GPU:
    ~ 169 GB/sec. currently
    ^

    Apples to orange regarding software
    ....I don't have to flash bios to use AB.

    Latency is just the other side of coin in memory OC
     
  6. rewt

    rewt Guest

    Messages:
    1,279
    Likes Received:
    15
    GPU:
    Yes
    Enjoy your fruit. Bold font isn't going to make it happen any sooner.
     
  7. collinvue

    collinvue Member

    Messages:
    48
    Likes Received:
    0
    GPU:
    ~ 169 GB/sec. currently
    ^

    yep, point taken

    ~:)
     

Share This Page