laptop - broken hinges

It doesn't look very pretty because the piece got bent while i was cutting it, but nothing that a hammer couldn't fix. Right now this is quite strong, but i also plan to connect everything together with solder and epoxy. After i remove the vertical screw it will fit nicely into laptop case.

 

A couple of small countersunk screws + nut would fit and reinforce it nicely.

 

Sadly i do not have smaller nuts and screws, but those should do ok, like i said, it fits )

 

Here is a little update on how things are coming along so far.

 

It looks good, should be strong enough