Hi there all, I have one big problem in a 3D geological modelling software. I could provide a youtube link that shows the problem. The problem is about two surfaces which should be solid but as I go from below one of them the other one (which should be in front after the rotation and block the visual of the previous) disappears like it has 100% transparency being rendered only on the sides. It is quite difficult to describe this in only words, but Guru3D does not let me attach link because I am new. I am using a AMD R9 290x MSI GPU, 16 GB DDR3 RAM and AMD 6100 processor. Thank you very much! PS: Please forgive my bad English. Best regards, Tony
Hi Tony Did you tried export model as obj to other program such as 3DS Max or free SW Blender? Or DAZ3D Studio? There you can check if model is correct or does have correct transparencies Did you applied any transparency/opacity map to yours model? Or can you post link on the model and I can check that? Or is this model only single sided,this has happen to me few times Hope this helps Thanks,Jura
