Sorry for this newbish question, but normally I'm a ATT user Right now I have set RT, that at startup of the program a specific GPU clock and voltage gets set - which works fine When I exit the program it should set it settings back to default. I did the voltage via the Scheduler as this setting doesn't normally change, but I have a problem with the clocks. Of course I could do the same with the clocks but then they are set strict. So if I set it to default 750/900 it can't go automatically back to 500/900 when not in 3D mode. If I disable low-level system setting however, the clock could again adjust itself. So is there some way to disable it on exiting RT?