Just bought this board yesterday to go with my FX9590 All of the kit was taken out of working system that was using a Asus Crosshair v Formula and it was working fine. My ram was running at XMP1.1 DDR3 2000Mhz 9-9-9-27-2T 1.65v in the crosshair board. On this Board I cannot get the ram past DDR3 1333 no matter what i try?? its not a problem with the ram as if it was it would not even run at 1333Mhz, Any suggestions please this UEFI bios is a bit weird for me especially coming from Asus UEFI bios, I might be missing an obvious setting Many thanks
Sorry what I meant to say was I set the timing and freq manually on the CHV formula and it ran fine. my question why can I not do the same with this board and cannot change the divider higher than 1333?