Hi I just bought a new r9 280x powercolor. I installed it on my pc but it doesn't do anything it just shows a black screen and says no signal. My pc is Msi pa67-gd65 16 gb of ram Intel 2600k And I had a Radeon 6970 Please help of you can
Is it seated in the slot properly? Are the power cables connected correctly both ends? Is the monitor plugged in correctly? Is the source set correctly on the monitor (dvi/hdmi/displayport etc)? Is the bios set to pci-e for graphics?
Yes the card is connected correctly and and psu is 1000 Watt and I have selected the right input for TV.With my old card 6970 pc power up instantly with the new I can't even hear the beep that was from the pc with the other connected Also the fans on the card are working and the cpu fan is adjusting on the temperature but I don't have any image it always show no signal
If you can, try both HDMI and DVI ports. Also , try clearing your motherboard's CMOS and see if that helps
Possible Solution Have you found a solution to your problem yet? If not I had the same problem until I updated my motherboards bios. I have a MSI Z68A-GD65(G3). Once I updated my bios the card worked fine.
