X800XTPE won't hold overclock

Discussion in 'RivaTuner Advanced Discussion forum' started by uclajd, Jun 17, 2005.

  1. uclajd

    uclajd New Member

    Messages:
    2
    Likes Received:
    0
    I'm using 5.2 and the newest Riva build. When I set an overclock on my X800XTPE, once I run 3DMark, it reverts back to default speeds.

    Any idea what causes this? Happened in 5.6 as well.

    I know temps aren't the problem. :D

    [​IMG]
     
    uclajd, Jun 17, 2005
    #1
  2. Unwinder

    Unwinder Ancient Guru Staff Member

    Messages:
    17,196
    Likes Received:
    6,846
    Use RivaTuner's hardware monitoring module and examine clock frequency history graph instead of overdrive
     
    Unwinder, Jun 17, 2005
    #2
  3. uclajd

    uclajd New Member

    Messages:
    2
    Likes Received:
    0
    I have been using it. Riva shows the clock fine, but as soon as I run a bench, it reverts.

    Overdrive pic was just to show off temps (currently, Catalyst Control Center is not even installed). Speaking of which, 15.5 shows subzero temps better than earlier versions.
     
    uclajd, Jun 17, 2005
    #3
  4. Unwinder

    Unwinder Ancient Guru Staff Member

    Messages:
    17,196
    Likes Received:
    6,846
    Are you sure that you've no ATITool/ATITrayTools residing in memory?
     
    Unwinder, Jun 20, 2005
    #4

Share This Page