 |
|
|
|
 |
 |
 |
 |
|
|||||||
 |
 |
 |
RivaTuner Advanced Discussion forum This forum is intended for advanced comments, ideas and general discussion of the RivaTuner Utility which is hosted here at the Guru of 3D. This forum is visited by programmer himself - you can only post in this area with a minimum of 10 posts and 7 days forum membership.
|
|
 |
|
|
Thread Tools | Display Modes |
 |
Riva tuner VGA change question |
 |
|
|
|
(#1)
|
|
Newbie
Videocard:
Processor: AMD Sempron 2800+ @2200
Mainboard: Asus K8N4 E-SE
Memory: PQI 1GB DDR400
Soundcard:
PSU: 300W
|
Riva tuner VGA change question -
06-12-2007, 13:29
| posts: 2
Maybe this problem is described here before, but i couldn't find a solution, so im posting.
My old VGA (eax 550)was clocked via RivaTuner from a standard 400/250 to 500/270. Now if i change my VGA (eax550) with a new one (7300GT) will the program detect that im with new VGA and run it on the default settings (500/~700) ? Or do i have to enter safe mode and remove RivaTuner from the bootup list and add it later when i start Win normally? |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
(#2)
|
|
Master Guru
Videocard: Gigabyte 8800GTX 768MB
Processor: A64 X2 4600+
Mainboard: Asus A8N32SLI Deluxe
Memory: 2048 Corsair DDR
Soundcard: X-Fi Gamer + Logitech Z5500
PSU: HPC-560W
|
06-12-2007, 14:44
| posts: 789 | Location: Romania
Just replace the vga board and boot up the computer. Everything will work just fine, no need to boot on safe.
|
|
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Powered by vBulletin®
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright (c) 1995-2012, All Rights Reserved. The Guru of 3D, the Hardware Guru, and 3D Guru are trademarks owned by Hilbert Hagedoorn.