 |
|
|
|
 |
 |
 |
 |
|
|||||||
 |
 |
 |
ATI Tray Tools Generic Discussion This forum is intended for comments, ideas and general discussion of the ATI Tray Tools Utility which is hosted here at the Guru of 3D. This forum is visited by programmer himself.
|
|
|
|
Thread Tools | Display Modes |
 |
ATI tray tools using ATI Overdrive 3 |
 |
|
|
|
(#1)
|
|
Newbie
Videocard:
Processor:
Mainboard:
Memory:
Soundcard:
PSU:
|
ATI tray tools using ATI Overdrive 3 -
01-25-2007, 16:52
| posts: 13
I have an X1950XT and am using the ATI overdrive function in ATI tray tools but have hit a little snag. The maximum memory OC listed in the ATI overdrive section (891Mhz) is still below the default 3D clock for the memory in CCC (900Mhz). Not to mention the fact that I know I can get at least 945Mhz out of this memory in CCC.
Is there any way of adjusting the maximum memory OC setting? |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
Powered by vBulletin®
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright (c) 1995-2012, All Rights Reserved. The Guru of 3D, the Hardware Guru, and 3D Guru are trademarks owned by Hilbert Hagedoorn.