 |
|
|
|
 |
 |
 |
 |
|
|||||||
 |
 |
 |
ATI Tray Tools Generic Discussion This forum is intended for comments, ideas and general discussion of the ATI Tray Tools Utility which is hosted here at the Guru of 3D. This forum is visited by programmer himself.
|
|
|
|
Thread Tools | Display Modes |
 |
Why is OC locked out in ATI Tray Tools, X1800XL? |
 |
|
|
|
(#1)
|
|
Newbie
Videocard: ATI X1800XL
Processor: AMD 3500
Mainboard: Abit AN8 Ultra
Memory: 1gx2
Soundcard: Abit On Board 7.1
PSU: ASPIRE 680W
|
Why is OC locked out in ATI Tray Tools, X1800XL? -
09-11-2006, 01:49
| posts: 6 | Location: Florida
I posted the below words in a different part of the forum, wrong place, I asked for it to be deleted so I could post this here.
Hello everyone... I am sure this could be a flame on the new guy on the block for asking this, it HAS to be talked about here somewhere... I am using ATI Tray Tools (v1.05.880 RC) with a X1800XL ATI card and the latest Omega drivers. Problem, the OC settings are locked out for me, is this a problem on my end or ATI Tray Tools? Any help would be great. To add, I did have the ATI Tray Tools installed that comes with Omega and had this same problem, I did remove them and install Tray Tools on it's own and the problem is still there. Pic below... |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
Powered by vBulletin®
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright (c) 1995-2012, All Rights Reserved. The Guru of 3D, the Hardware Guru, and 3D Guru are trademarks owned by Hilbert Hagedoorn.