 |
|
|
|
 |
 |
 |
 |
|
|||||||
 |
 |
 |
ATI Tray Tools Generic Discussion This forum is intended for comments, ideas and general discussion of the ATI Tray Tools Utility which is hosted here at the Guru of 3D. This forum is visited by programmer himself.
|
|
|
|
Thread Tools | Display Modes |
 |
 |
|
|
|
(#1)
|
|
Videocard:
Processor:
Mainboard:
Memory:
Soundcard:
PSU:
|
12-01-2001, 16:01
| posts: n/a
Hi anybody! <br>
<br> I flashed my ELSA GLADIAC MX to a Quadro2 MXR/ER. I changed the device ID from 0110 to 0113. That actually worked. When I flashed my bios a message appeared that all worked properly... <br> I rebooted and saw the new BIOS-Msg I added. So this also worked... <br> <br> But: In Windows (I'm using XP) the system management shows my old Gladiac again. Nothing changed... The core-clocks are the same and it's still my old MX <br> <br> If I load my current bios it shows all the changes I made. ALL changes... even the Quadro. <br> <br> What Did I do wrong? Or did it work but my Windows doesn't recognize the change...? Anyone had equal troubles? Please help me out of this mess... <br> <br> cYa <br> Blaxxun<br><br><i>This message was edited by Blaxxun on 01 Dec 2001 05:28 AM</i> |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
Powered by vBulletin®
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright (c) 1995-2012, All Rights Reserved. The Guru of 3D, the Hardware Guru, and 3D Guru are trademarks owned by Hilbert Hagedoorn.