 |
|
|
|
 |
 |
 |
 |
|
|||||||
 |
 |
 |
Benchmark Mayhem This section is for you benchmark freaks. Wanna show off your 3D Mark Vantage scores with your brand new GTX 295 SLI or Radeon HD 4870 X2 Crossfire in that Intel Core 2 rig? Then this is your section!
|
|
|
|
Thread Tools | Display Modes |
 |
 |
|
|
|
(#1)
|
|
Videocard:
Processor:
Mainboard:
Memory:
Soundcard:
PSU:
|
06-15-2002, 13:48
| posts: n/a
I had problems running 3DMark 2001se with my ti4200, so I<br>
installed the latest detonater drivers ad raised the clock speeds to 275/545 and it ran fine. <br> <br> However my score at the end was around 5900, which is very low for my system which is:<br> <br> Tbird 1000 @ 1200mhz<br> 512 mgs SDRam pc133<br> Gainward ti4200 64mgs DDR<br> <br> Other people with this setup are getting around 8000.<br> <br> I tried disabling Vsync and FSAA as IO heard this helps, but now 3Dmark says my 3D card is not good enough to run the benchmark test. <br> <br> Any suggestions?<br><br><i>This message was edited by KrazieBone on 15 Jun 2002 09:48 AM</i> |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
Powered by vBulletin®
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com
Copyright (c) 1995-2012, All Rights Reserved. The Guru of 3D, the Hardware Guru, and 3D Guru are trademarks owned by Hilbert Hagedoorn.