Problem trying to install 3 x 4 GB G.Skill Ripjaw RAM on X58 motherboard

Voltage: 1.5000
QPI / Uncore Voltage: 1.2500
Uncore Multiplier: 24
Memory Multiplier: Speed: 12:1600

tCL: 9
tRCD: 9
tRP: 9
tRASmin: 24
tRFC: 128
tRRD: 5
tWR: 12
tWTR: 6
tRTP: 6
tRC: 37
tFAW: 24
tCWL: 9
Command Rate: 2T


Just pulled it from my BIOS, cause I'm to lazy to find the thread on G.Skills forum. These are settings with out any sort of overclocking applied to my RAM or my CPU. I run an i7 960 at defaults, my little forum side bar info is wrong at the moment.

 

Thanks for that, HolyLiaison. I've just checked with AIDA64 and of the values it shows, those correspond to the timings you've posted which is great because I only set the first four manually, the 2T Command Rate and the 1.5 V DRAM voltage.