For peoples who have problem with Vantage, try uninstall PhysX driver, clean it and reinstall it ... be sure to uncheck it too on driver cause new vantage version no more allow the use of PhysX during Vantage test .. as the driver try force it if checked, and vantage do the invert this cause trouble . it can be caused too by the system information files.. delete them in ALL 3Dmark folders, download the system information update and reinstall it. I have just run it, after install 3Dmark 03-05-06-11 and then vantage, no problem at all ..
And here end my benching adventure.... my pc just died get a boot led on the mb, all fans work but thats it, the only good thing is it powers down and resets np so hopefully its the gpu and not the cpu... ive got no old parts all sold to get the second 570 im getting next week:-[
Black screen and the monitor don't pop up ? - try reset completely the CMOS - check your rams, maybe one is killed . ( remove one, try then the other ) - if you have a soundcard, try remove it and boot without it, same for other " PCI, PCI ex .. - unwire the HDD's and try boot without it, a Sata problem can be the cause. - check what mean the post led numbers during boot . If all seems normal, but no screen, try other DVI, HDMI port > an other monitor. Who know ... maybe not what you think. if it was the GPU ( outside video output ), the card will get a led who blink .
Submitted a SuperPi result, but I had to change my CPU model because hwbot says my 255 doesn't exist....go figure. I'll crank my OC up to 4Ghz and resubmit, hopefully that'll get some more points..
well to be honest that 1.55v looks dangerous @ air.. try resetting comos, if that doesn't help remove cpu and check if there are any burned pins on socket /contacts on cpu.
+1 1.55v your 24/7 volts @ 5.5? I run mine 4.7ht on and off 1.36v on air 1.5ish is ok for short benchies
Ok went to the local pawn shop and got a x600 for a fiver. it works ergo gpu died.... second one in the last 3 weeks... first brand new 560 and now the replacement 570.... is it possible my mb is killing them? i still have the rev b till they replace it next month. if it goes for the cpu i only run it at 1.55 for benches, for every day use its 5ghz at 1.3 and the temps are max 72 after 100 max runs of ibt. so hello rma again... up side is i should get some sick scores in 3dm2001 with that x600 in its category;-) maybe even 2005;-) you grt seprrate points for different gpu right? or is it just the best you have with your profile?
tommy i would delete your prime score then edit them..0.0 sec. is a weee bit to fast. good job on vantage thuo.
all cards have there own class witch gets points plus each card has multi gpu also if they can cf/sli/tri/quad
So an x600 with a 5ghz sb should get a wopper place in its own category in 3dmarks 2001,2003,2005,2006