MSI AFB unofficial 1080TI support

Discussion in 'MSI AfterBurner Application Development Forum' started by famich, Mar 11, 2017.

Thread Status:
Not open for further replies.
  1. famich

    famich Active Member

    Messages:
    92
    Likes Received:
    1
    GPU:
    GTX 780TI SLI@1250
    Hello everybody,
    I did not quite understand the explanation at the end of H Hagedoorns review of 1080TI regarding the support for overclocking/overvolting of 1080Ti un MSI AFB.

    Which section exactly should I edit and should I put those lines at the end of the file ? Most probably exactly so, but ,please, another "how to" would be appreciated.
     
    Last edited: Mar 11, 2017
  2. Unwinder

    Unwinder Ancient Guru Staff Member

    Messages:
    17,123
    Likes Received:
    6,688
    You shouldn't edit a section, you should add new section as shown in the review.
     
  3. famich

    famich Active Member

    Messages:
    92
    Likes Received:
    1
    GPU:
    GTX 780TI SLI@1250
    OK, that is what I did not understand properly. I will do it. Thank you !!!

    Tried to add the new section at the end of the .oem2 file , however, no detection after the restart. Must be doing it wrong, suppose.
     
    Last edited: Mar 12, 2017
  4. MDKpt

    MDKpt Active Member

    Messages:
    90
    Likes Received:
    14
    GPU:
    Suprim X 4090
    its not working the explanation is very very generic

    cant add voltage


    cheers
     

  5. Unwinder

    Unwinder Ancient Guru Staff Member

    Messages:
    17,123
    Likes Received:
    6,688
    Everyting is working if you're able to follow trivial instructions. If it is too complex for you - wait for official build.
     
  6. MDKpt

    MDKpt Active Member

    Messages:
    90
    Likes Received:
    14
    GPU:
    Suprim X 4090
    http://prntscr.com/ej3lno

    its not trivial


    http://prntscr.com/ej3md1

    the problem is the way the info was typed its misleading thats all

    cheers
     
    Last edited: Mar 12, 2017
  7. Unwinder

    Unwinder Ancient Guru Staff Member

    Messages:
    17,123
    Likes Received:
    6,688
    If it is not trivial for you, then it is NOT intended for your skills. Please don't mess with third party voltage control mode and wait for official build having those changes built-in. Thread is closed, sorry. Those who want to unlock it and can do it have enough info in Hilbert's review.
     
Thread Status:
Not open for further replies.

Share This Page